Applications
Induction Hardening
Hardening with induction heating
Hardening is the process of heating the material above 900°C temperature followed by quenching. Hardening is usually increasing the hardness.
Induction forging
Forging with induction heating
Forging is the process to make different shape of the component by heating and hammering or by application of contact forces.
Induction Annealing
Induction Annealing
Annealing is a process involving heating and cooling, usually applied to produce softening. The term also refers to treatments intended to alter mechanical or physical properties, produce a definite microstructure, or remove gases. The temperature of the operation and the rate of cooling depend upon the material being annealed and the purpose of the treatment.
Induction Brazing
Brazing with induction heating
Brazing is a metal-joining process in which two or more metal items are joined together by melting and flowing a filler metal into the joint, the filler metal having a lower melting point than the adjoining metal.
Induction Normalizing
Induction Normalizing
Normalizing is a type of heat treatment applicable to ferrous metals only. It differs from annealing in that the metal is heated to a higher temperature and then removed from the furnace for air cooling. The purpose of normalizing is to remove the internal stresses induced by heat treating, welding, casting, forging, forming, or machining.
Induction Tempering
Tempering with induction heating
Tempering consists of heating the steel to a specific temperature (below its hardening temperature), holding it at that temperature for the required length of time, and then cooling it, usually instill air. The purpose of tempering is to reduce the brittleness imparted by hardening and to produce definite physical properties within the steel.
Induction Shrink fitting
Induction Shrink fitting
Shrink fitting is a process of heating and cooling the component for interference fit.
Induction Soldering
Induction Soldering
Soldering is the process joint two metal pieces with filler material.